SF600Plus is high speed "in System Programming" programmer to update the SPI Flash soldered on board (In Circuit Programming) or in the socket adaptor (Offline programming). The programmer is easily controlled by the computer DediProg Software through the USB bus offering a friendly interface and powerful features to users.
SF600Plus combines the advantages of SF100 with additional improvements: High-speed USB and higher SPI performances.
SF600Plus is an upgrade version of SF600. The main difference is that SF600Plus embeds an 8GB memory, which allows standalone programming.
- USB High speed and high SPI performance, support up to 2Gb SPI Flash
- In-Circuit Programming: Program on board SPI Flash
- Off-line Programming: Program SPI Flash in the socket
- Start button feature: Able to Batch in the USB mode
- Standalone mode: Support Start button programming and IO Port programming.
- Program two Serial Flash memories
- Signal conflict protections
- Multi-Programmers Capability through USB
- Support 1.8V low voltage IC
- Support Windows 2003 and above
- Support both 32 and 64 bit OS
- Support 1 CS pin
High performance (25MHz, Single IO):
|USB Mode||Reference IC||Density||(Program + Verify)|
*Please note the programming and verify time will depend on different IC type; please refer to the IC specification before programming.
SF600Plus is designed with ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. Please refer to Table 1 for the SF600Plus 2x10 header pin out. DediProg also provides the SF600Plus ISP Cable which is used to connect the programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to Table 2 for the SF600PlusISP Cable 2x6 pin out.
Table 1: SF600Plus ISP Header Pin Out (2x10)
Table 2: ISP Cable Connector Pin Out (2x6)
The SF600Plus USB software tool chain offers high flexibility and fits the different and highest requirements:
Hardware Requirement for ISP :
SF600Plus Programmer x 1
USB Cable x 1
AC Power Adaptor (ME-SW-ADP-1) x 1
ISP Cable (ISP-600-CB1-G) x 1
SF100 2.54mm 2*4 ISP Cable (ISP1-CB) x 1
SF600 Universal Adaptor (ADP-SF600-TO-SF100) x 1
CD-ROM (Included Software, specifications and user manual) x 1
- Backup Boot Flash Module-8N
- Backup Boot Flash Module-8W
- Backup Boot Flash Module-D8W
- Backup Boot Flash Module-DIP
- Backup Boot Flash Module-16W
- Backup Boot Flash Module QUAD-8W
You might also like